Microsoft Exchange Relaying feature

While configuring SAP Connect with Microsoft Exchange server, SAP could send the mails to internal email addresses but couldn't send to email addresses out of domain. This is because of Exchange relay feature (quoting)
http://technet.microsoft.com/en-us/library/dd277329.aspx
"To allow specified IP addresses—internal or external—to relay, check the "Hosts and clients with these IP addresses" checkbox, then use the Add, Edit, and Remove buttons to build the list of IP addresses from which you want to accept relay traffic. Remember that this checkbox controls relaying when you have selected the radio dial for "Reroute incoming SMTP ..." in the Routing tab. You should normally check this box; doing so will prevent relaying. If you leave it unchecked, your server is open for relay."

But the confusion remained from normal IP address 192.168.1.x we can send mail to outofdomain email addresses but why not from SAP servers (because they are on 192.168.213.x IP range ) :-)

If the administrator wants he may allow the same (192.168.213.x) as well to relay to outofdomain email addresses.

We were getting (Value is obsolete) in Operating System MTE in RZ20. We followed the below link :
http://help.sap.com/saphelp_nw04/helpdata/EN/28/58b3d95bcea54d81e76b2ec122c564/content.htm
You can also reset the method status by selecting the corresponding MTE, choosing Display Details (), and, on the following screen, choosing Edit ® Method Status ® Reset ® Select Data Collection Method and it resolved the same.

5 steps to configure HADR on db2

Here is all the setup required for HADR on one slide. Note the steps are quite simple.
Backup database on primary
Restore database on secondary
Set config parms (which are all pretty straight forward, hostname, port to listen on, remote instance name)
Start standby
Start primary
That’s it!

SAP may remain up during offline database backup

Within an SAP environment, the SAP system may remain up and running during an offline backup to preserve the buffers of the SAP application servers. All SAP work processes are disconnected from the database and remain in a reconnect state during the offline backup. After the backup has been finished, the work processes reconnect to the database using the reconnect feature of the SAP Database Support Layer (DBSL). - DB2 UDB for SAP Guide